Yuav ua li cas xaiv CPU heatsink

      Generally speaking, the most economical cooling fan for computers must be the heatsink made of aluminum alloy. The reason why aluminum can be used as heat sink is that aluminum is not very light and has good thermal conductivity. Therefore, it is widely used as the best material for heat dissipation of electronic parts. However, the heat sink is not 100 percent pure aluminum, because pure aluminum is too soft, so a small amount of other metals will be added and cast into aluminum alloy to obtain appropriate hardness.

     Another material is copper. Copper has better thermal conductivity than aluminum, but the cost is much higher than aluminum heatsinks. Considering the cost, pure copper heatsinks are generally used for high-end radiators, and the cost is relatively high. Another point is that the pure copper heatsink is heavy and easy to bend and deform the main board. Now there are relatively few products using pure copper heatsink.

HeatPipe heatsink:

     The heat dissipation effect of the heatsink with heat pipe is much better than that of ordinary products. This is because the copper heat pipe contains flowing heat-conducting liquid, Through the flow of liquid (the principle of thermal expansion and cold contraction), it can quickly take away heat, and then cooperate with the heat sink to conduct heat. The cost of heat pipe heatsink is naturally much higher. If the thermal power consumption design of CPU is not particularly high, it is not necessary to buy high-end heatsinks such as 5 heat pipes heatsink. At most, 3 heat pipe heatsinks are enough.

Ntxuam Loj:

     Tus tsim ntawm qee qhov CPU heatsinks yog exaggerated tiag tiag. Ntxiv nrog rau cov qauv ua qauv, ntau tus tau nruab nrog cov kiv cua txias loj ntawm 8cm lossis txawm tias 12cm, yog li ntawd cov huab cua ntim loj dua thiab cov cua sov dissipation zoo dua. Txawm li cas los xij, hom kiv cua no muaj qhov xav tau siab rau qhov chaw teeb tsa. Tshwj xeeb, lub cim xeeb qhov tsim los ntawm qee lub motherboards ze dhau (lossis lub cim xeeb ntawm lub dab dej kub siab dhau lawm), lossis lub dab dej kub siab dua yog ntsia rau ntawm lub hwj chim module, uas yuav ua rau nws tsis tuaj yeem nruab. Nco ntsoov paub qhov siab ntawm koj lub motherboard ua ntej yuav khoom.

Down los yog sab tshuab:

      There are many kinds of CPU cooling fans, but they are inseparable from the most basic technical features, and the cooling wind direction is one of them. In the early years, the CPU fans of computers were very simple, It is down blow type,the fan blowing downward facing the CPU; Now there is also a side blowing mode. The fan is designed on one side of the CPU radiator to blow from the side.

     Compared with the heat dissipation methods of the two CPU heatsinks , the down blow type is more effective and intuitive; For players who want to meet the heat dissipation requirements and intend to build an overall heat dissipation channel, they should choose side blowing heat dissipation. However, this is also related to the air duct in the chassis - if it is a compact chassis and no heat dissipation equipment is planned to be installed on the front and rear sides of the chassis, the down pressure radiator is the best choice.